03.02 Power-On and Automatic Connection

Open manual menu
  1. Business Customer / Developer Integration Manual
  2. 3.2 Power-On and Automatic Connection

3.2 Power-On and Automatic Connection

The Commercial Edition requires no pairing. After the matching receivers are connected and the gloves are powered on, the devices should automatically establish communication over the preset channels.

Procedure

  1. Confirm that the gloves and receivers belong to the same channel group.
  2. Connect the matching receivers to the customer's computer or project device.
  3. For the Standard Edition, confirm that 1 receiver is connected; for the Haptic Feedback Edition, confirm that all 2 receivers are connected.
  4. Power on the left and right gloves and wait for the project system to read the device data.
  5. Move each finger on the left and right hands separately. Verify that the left/right assignments and data sources have not been swapped.
  6. For a multi-pair deployment, repeat the check for each pair and record the results.
Verify the channel groupDo not mix receivers
Connect the receiversStandard Edition: 1 / Haptic Feedback Edition: 2
Power on the glovesNo pairing required
Check the dataVerify the left and right hands separately

If Automatic Connection Fails

Do not start the consumer pairing process. First check the USB connection, power supply, and channel group. If there is still no data, record the asset IDs, receiver combination, and project environment, then contact support.

Next Step

After the connection is established, proceed to 3.3 Finger Flexion Calibration Using the Menu Button.